ACURA INTEGRA GSR VTEC THROTTLE BODY INSTALLATION INSTRUCTIONS

1. Please read through the entire instruction sheet to familiarize yourself with the parts of the vehicle the installation will deal with.
2. Start the engine and check for loose connections or coolant/vacuum leaks, etc.
3. Disconnect the negative battery terminal.
4. Remove the air filter duct, all vacuum hoses, water (coolant) hoses and electrical connectors from the stock throttle body. Mark all hoses and wires to ensure that they are installed correctly on the new throttle body. Note: Engine coolant may run from the hoses once removed.
5. Rata PenuhDisconnect the throttle linkage by opening the throttle manually and slipping the cable from the cam groove on the linkage.
6. Remove the four nuts securing the throttle body to the intake manifold and remove it.
7. Remove the MAP (see Figure 1 for MAP sensor location) sensor from the factory throttle body. Use the new O-ring with the blue stripe from the kit contents to seal the MAP sensor to the throttle body. Attach the MAP sensor to the new throttle body using the factory screws.
8. Remove the idle air control (IAC) motor (see Figure 1 for IAC motor location) from the factory throttle body. Using the factory bolts and the O-rings supplied in the kit, attach the IAC to the new throttle body. The o-rings are color-coded so refer to Figure 1 for proper installation. Torque down bolts to 10 N·m or 7 lbf·/ft.

here

Tweet