Use the cruise control paddle from the 89+ supra as a built in paddle shifter. Stock cruise control operation is retained when the Suprastick is in the “Fully Automatic” mode. The white Manual / Auto selector lead may be wired to the #2 in the wiring diagram and use the ECT switch next to the gear shifter for mode selection, or any 12 volt switch and source.
The cruise control paddle wire is located under the driver’s side dash. It is the pink /green wire in the wire loom coming from the steering wheel and connecting to the cruise control ECU. It will shift voltages when the paddle is pressed up or down, and be constant 12 volts when the paddle is not touched.
After connecting all of the SupraStick wires, but before replacing the kick panels and glove box, start by turning the car’s ignition to on (do not start the car). The SupraStick unit will click twice. Select manual shifting mode. Shift up and down through the gears. You should hear a distinctive click in the SupraStick box and in the tranny for each shift. You may verify the following voltages on wires 13-15 for each gear.
here
The cruise control paddle wire is located under the driver’s side dash. It is the pink /green wire in the wire loom coming from the steering wheel and connecting to the cruise control ECU. It will shift voltages when the paddle is pressed up or down, and be constant 12 volts when the paddle is not touched.
After connecting all of the SupraStick wires, but before replacing the kick panels and glove box, start by turning the car’s ignition to on (do not start the car). The SupraStick unit will click twice. Select manual shifting mode. Shift up and down through the gears. You should hear a distinctive click in the SupraStick box and in the tranny for each shift. You may verify the following voltages on wires 13-15 for each gear.
here
0 Response to "TOYOTA SUPRA MKIII INSTALLATION MANUAL"
Post a Comment